Sonifex S2

Productbeschrijving

•The S2 chassis is available in 5 module width sections, allowing 5, 10, 15, 20, 25 and 30 module width mixers. This means S2 can be used for small newsrooms or large on-air situations.
•Modular “pop-up” input and output channels means that the mixer can be maintained simply and quickly. Hot-swappable input channels can be individually removed and repaired whilst still on-air.
•The angle of the meterbridge can be varied and set for best viewing position.
•Any module can be in any position so that customising the mixer for your own purposes is easy.
•Large back-lit buttons allow you to see the status of the mixer at all times.
•The fitted rear panel hides all cable connections but can be simply unclipped and reclipped for maintenance.
•The modular design of the desk gives you the flexibility to expand it at a later date. You can even add another S2 mixer and link them together with a bus connector cable to allow for split desk configurations.

S2 Input Channels - Intro
There is a wide choice of input channels for the S2 mixer. Each channel has a number of common features :

Assigning an Input Channel to an Output Bus - Switches at the top of the channel are used to select the output group routing, to either Program, Audition, or both output busses. Selecting the PGM and/or AUD buttons routes the channel audio to the PGM and/or AUD mix busses. The buttons illuminate green to indicate the routing status.

Changing the Input Level - Coarse gain is set using pre-set potentiometers on the channel circuit board which allow unbalanced inputs to be used on mono and stereo line inputs. The front panel TRIM control allows fine gain of ±12dB.

Changing the Signal Pan, or Balance - The BAL/PAN control is used on mono channels to pan the mono input signal in the stereo image and on stereo channels to balance the stereo image.

CUE/PFL (Pre Fade Listen) - Selecting the CUE/PFL button routes the pre-fader input signal to the monitoring system where the signal can be heard via headphones and/or loudspeakers. The button lights green when CUE/PFL is active and a jumper option is available to cancel the CUE/PFL selection when the fader is raised. This button works with both a momentary and latched operation - if held down, the selection is cancelled on release, otherwise the button is alternate action.

Fader Start & ON Button Control - The ON button works in conjunction with the 100mm long-throw carbon fader and is used to control channel remotes (e.g. starting a CD player), routing and timers, etc. When unlit, the channel is off. Flashing red indicates that the channel has been selected to ON but not routed to either PGM or AUD. Steady red indicates that the channel is ON and “armed”, ready for the fader to be raised. Raising the fader changes the illumination to green indicating that the channel is live. Alternatively, with the button unlit the fader may be raised and the channel can be operated simply by selecting ON. The illumination in this case toggles between unlit (channel OFF) and green (channel ON).

Programmable Button Settings
To make the S2 modules as flexible as possible, every button on each channel can be set to a number of different modes to aid the use of the mixer and allow for extra functionality. Each button can be set to either operate manually, be permanently on, or permanently disabled. Also, the ON button can be configured to operate in a number of modes, altering remote start functions, and the channel ON function can be controlled remotely by automation playout systems, such as RCS® or VCS.

Scribble Pad - A scribble pad is provided at the bottom of the channel for user labelling of the channel function.